What's best method? Have a recessed panel door and was able to remove all the flat area…the reveals are proving near impossible.

Tried some orange non Voc stuff from Lowe's, some chemicals, specials blades scrapers and now a sandblaster with baking soda. Next step is changing the blast media and going to crushed walnut.

Sand paper and elbow grease . Roll up and get to it, is best I've found.

You can use a heat gun to make it peel up.

You need some VOCs to get all the paint off. Use a respiratory and kill some ozone. You'll be fine.

Hit it with a power washer and a light sanding and you should be good

https://speedheater.com/en/product/speedheater-cobra/

Spend the money and use one of these. You can have that door stripped and sanded by lunch time. This is the expensive Texags way.

They actually work very well. I bought one a few years ago for a big project and have been very happy with it. It's very fast and is supposed to be safer than a heat gun if you have an issue with lead paint.