We have an angled wall in our bedroom that we plan on mounting a tv to. We will need a full motion one as the bed does not line directly up with this wall. Anyone have suggestions on a full motion low profile wall mount?

Look at Sanus and Chief. Both have full motion options of varying depths. Also, if your walls are thick enough, they sell mounting boxes, that accommodate the motion arms, that allow a TV on a full motion mount to sit flat to the wall.

Chief mounts are awesome, pricey but worth it if you hanging an expensive tv or projector. I have two, one for my projector, and a full motion for the flat screen.

I'd suggest getting a full motion, normally they are only $75 more. I didn't know if it would be worth it, but I am very happy I went with it. Good luck

How big is the TV?

This one from Monoprice has worked very well for me: http://www.monoprice.com/products/product.asp?c_id=108&cp_id=10828&cs_id=1082806&p_id=7845&seq=1&format=2

I know some people poopoo Monoprice, but I have had three of their mounts, and I have never had a problem.

I have this Monoprice one for my Samsung 59 inch. It is very well made with only one complaint - the knobs to hold the tilting position are too small to tighten easily by hand. It is a very solid and sturdy mount.

I have the same one Spicewood shows above to hold my 60" Sony.

Agree on the tilt knobs. Can't even get to them to tighten them...very poor design

This is just our bedroom TV so it will probably be around 46"

I've got a Peerless full motion in wall to handle my fatty plasma in the living room. No complaints so far and I have no issues extending it the full 20" from the wall when I want the display to be 20" closer to my face. Motion is as smooth as the day I installed it and the tilt and rotation settings stay constant throughout the full range of motion.

not directly on topic, but I just want to pitch these toggle bolts for folks who have a mount that doesn't line up with studs.

SNAPTOGGLE

Never install a TV wall mount with only drywall support. If you want to add a few toggle bolts to your mount after it's been bolted to 2 studs, fine.

I have one of those Monoprice mounts. I love it.

They are claiming 360lb per bolt in 1/2" drywall.

I still like my lag bolts into wood, but these drywall bolts are an awesome idea if they work as advertised

I used Cheetah mounts from Amazon

I have also use peerless

They are both great products that I would buy again

[This message has been edited by aggiewrench (edited 8/9/2013 2:00p).]

If using a mount flush with the wall, I see no problem using those snap toggle bolts.