Finished up some bigger projects and dropped them off yesterday:
Walnut headboard bed:
Honey locust table:
Pecan table from slabs I milled up:
This was the center cut of the tree. It had the most character, but also the most defects and voids/cracks that needed to get filled.
It also had metal every cut of the tree we did. I pulled most out before the slabs were flattened, marked where I pulled them, reinserted them with a little epoxy and then sanded them flush so you see them in the finish.
I think that slab had 7 pieces of metal (various nails and a lot of 22 bullets).
Walnut headboard bed:
Honey locust table:
Pecan table from slabs I milled up:
This was the center cut of the tree. It had the most character, but also the most defects and voids/cracks that needed to get filled.
It also had metal every cut of the tree we did. I pulled most out before the slabs were flattened, marked where I pulled them, reinserted them with a little epoxy and then sanded them flush so you see them in the finish.
I think that slab had 7 pieces of metal (various nails and a lot of 22 bullets).
