I have a little free time and am bored, so I figured I would post a build thread for my shop.
The building is 18'x35'x9'. I went with a building from Eagle Carports, with a few upgrades. I know a lot on here would prefer a mueller type building, but for my purposes and size, this was the best option. In fact, comparing the shop drawings that were sent to me from Mueller and Eagle, the Eagle building had higher wind loads and live loads by just a little.
Anyways, here are some pics.
I did all the dirt and form work, and had friends over to help with the place and finish of the slab.
[url=.html][/url]
[url=.html][/url]
The structure:
[url=.html][/url]
I had 3.5" of open cell insulation sprayed in.
[url=.html][/url]
Ceiling and Lights
[url=.html][/url]
Next, I stained the floor, this pic is when its still wet.
[url=.html][/url]
I put a corrugated wainscoting to help with sparks, etc.
[url=.html][/url]
I used OSB for the walls
[url=.html][/url]
The back wall is peg board, I painted it maroon.
[url=.html][/url]
Had a little help sweeping up so I could apply sealant to the floor.
[url=.html][/url]
Trim out of window and wainscoting
[url=.html][/url]
Any ideas on how to trim out the door? I can't use the 1x4 due to the difference in metal panel and OSB.
[url=.html][/url]
Concrete all sealed and done.
[url=.html][/url]
Since this picture I have run my air lines and installed my minisplit AC system (although it isn't charged yet).
Here is the exterior as seen from my backyard.
[url=.html][/url]
I don't currently have any of the front.
The building is 18'x35'x9'. I went with a building from Eagle Carports, with a few upgrades. I know a lot on here would prefer a mueller type building, but for my purposes and size, this was the best option. In fact, comparing the shop drawings that were sent to me from Mueller and Eagle, the Eagle building had higher wind loads and live loads by just a little.
Anyways, here are some pics.
I did all the dirt and form work, and had friends over to help with the place and finish of the slab.
[url=.html][/url]
[url=.html][/url]
The structure:
[url=.html][/url]
I had 3.5" of open cell insulation sprayed in.
[url=.html][/url]
Ceiling and Lights
[url=.html][/url]
Next, I stained the floor, this pic is when its still wet.
[url=.html][/url]
I put a corrugated wainscoting to help with sparks, etc.
[url=.html][/url]
I used OSB for the walls
[url=.html][/url]
The back wall is peg board, I painted it maroon.
[url=.html][/url]
Had a little help sweeping up so I could apply sealant to the floor.
[url=.html][/url]
Trim out of window and wainscoting
[url=.html][/url]
Any ideas on how to trim out the door? I can't use the 1x4 due to the difference in metal panel and OSB.
[url=.html][/url]
Concrete all sealed and done.
[url=.html][/url]
Since this picture I have run my air lines and installed my minisplit AC system (although it isn't charged yet).
Here is the exterior as seen from my backyard.
[url=.html][/url]
I don't currently have any of the front.