Was given a mower today that has a couple of holes in the deck. What is the most cost effective way to patch these? Don't care about the cosmetic appearance. Just don't want something to come flying up through the hole. Won't let me post a photo but it's about a half dollar size near the rear discharge.
Post Reply
1 of 1
Mower deck repair question
537 Views |
4 Replies |
Last: 3 yr ago by Ol Sarge Friday
Just throw some JB Weld on it. Maybe sand around it a little to promote adhesion or some chicken wire behind it if the hole's too big
Rusted through or did something fall off it? They sprayer holes for blade/deck wash down? Two fender washers and a bolt and nylon locknut might work.
Quote:
Just don't want something to come flying up through the hole. Won't let me post a photo but it's about a half dollar size near the rear discharge.
That's what she said?
Thin sheet metal, a rubber mallet, and some rivets are likely better than JB Weld and almost as cheap.
MouthBQ98 said:
Rusted through or did something fall off it? They sprayer holes for blade/deck wash down? Two fender washers and a bolt and nylon locknut might work.
Looks like it just rusted through.
Featured Stories
See All
LIVE from Olsen Field at BBP: No. 1 Texas A&M vs. Houston
by Richard Zane
8:16
9h ago
2.0k
FINAL/5 from Davis Diamond: No. 11 Texas A&M 12, Houston 2
by Emma Neuman
Dalton Hughes
"Big Ten will 'definitely' have Texas school by 2026"
in Billy Liucci's TexAgs Premium
136